Exit 16 construction to resume mid-September

Posted

COLCHESTER — Contractors may be on-site this week at the intersection of U.S. Routes 2 and 7 in Colchester to install construction signage. Work at the site is expected to resume in mid-September, according to the Vermont Agency of Transportation. 

After a months-long hiatus, phase two of the Exit 16 project will include the installation of the Diverging Diamond Interchange, additional turn lanes and pedestrian and bicycle accommodations. The Vermont Agency of Transportation awarded the work to S.D. Ireland Brothers Corporation for approximately $22.5 million.

Construction is anticipated to begin after Labor Day and conclude in summer 2027. 

Sign installation will occur predominantly outside the roadway; however, temporary shoulder or lane closures may be necessary on U.S. Route 2/7 north of Sunderland Woods Road and south of the Colchester/Winooski town line.

The project team will have more information regarding the official start date and anticipated traffic impacts of major construction activities after the schedule and traffic control plan have been approved. Additional project updates will be issued in the upcoming weeks.

In a Diverging Diamond Interchange, traffic crosses to the left side of the roadway, allowing traffic to make a left onto the interstate entrance ramps without crossing oncoming traffic. The reduction of conflict points eliminates potential collisions, improving safety and vehicle throughput. With left turn movements operating freely within the DDI, the traffic signals no longer require protected left turn phasing, improving overall traffic operations at the interchange.

Phase one of the project finished in fall 2023. That work involved utility upgrades and relocations, ledge removal, construction of retaining walls for future pedestrian and bicycle accommodations and installation of drainage infrastructure.

Sign up to get traffic alerts from VTrans by filling out this form.

Comments

No comments on this item Please log in to comment by clicking here